Astoria GLORIA AL Mode D'emploi page 189

11.3 MILK FOAMING adjustment
To adjust milk foaming with the ASD system, proceed as
follows:
• Use a wrench to unscrew component
steam nozzle;
• Use a screwdriver on the screw
- to reduce foaming turn clockwise
- to increase foaming turn counter-clockwise
B
12.
oiler pressure
Function not active.
W
13. ashing
13.1 Washing requested
The machine periodically suggests washing the milk circuit and the cappuccino maker.
This signal depends on the type of programming setting (see chapter 14).
To carry out washing proceed as follows:
1) Place the milk tube in cold water;
Additional
2) Press the key
Hot Milk
3) Wait for the washing cycle to be carried out (this takes roughly 30 seconds);
13.2 Voluntary washing
To perform washing of the milk circuit and of the cappuccino maker at any time, proceed
as follows:
1) Immerge the two milk tubes in cold water;
Additional
2) Press the key
Hot Milk
3) Wait for the washing cycle to be carried out (this takes roughly 30 seconds);
i
To interrupt the washing cycle before it has finished press the STOP button
To keep the cappuccino maker and its hydraulic circuit in perfect working order, it is advisable to
perform washing regularly.
Voluntary washing is possible only if the cappuccino maker has been enabled (see para. 14.11).
(A) of the ASD
(B) located inside the part:
BOILER PRESSURE
0.0 bar is=0.0
for three seconds (with programming key in the OFF position);
for three seconds (with programming key in the OFF position);
A
WASHING
CAPPUCCINO MAKER
Put MILK TUBEs
IN the WATER
PRESS button
"ADD. hot MILK" 3 sec.
Put MILK TUBEs
IN the WATER
PRESS button
"ADD. hot MILK" 3 sec.
.
41
DISPLAY - ASD / DS
B