Installing The Mulch Plug Or The Grass Bag - Toro 20899 Manuel De L'utilisateur

4
Installing the Mulch Plug or
the Grass Bag
No Parts Required
Procedure
You must correctly install either the mulch plug (for
recycling or side-discharging the grass clippings) or
the grass bag; otherwise, the engine will not start.
The machine has a safety switch (located at the
bottom of the channel on the upper right rear of the
machine) that prevents the machine from operating
without a mulch plug or a grass bag in place. This
prevents the machine from throwing debris at you
through the rear opening.
For the switch to detect the mulch plug, the top of the
mulch plug lever must lie fully in the bottom of the
channel (Figure 7).
1. The top of mulch plug lever in the switch channel
1. Insert the mulch plug into the machine if it is not
already installed
Figure 7
(Figure 8).
2. Squeeze the button on the lever with your
thumb, and fully insert the mulch plug into the
opening (Figure
3. Release the button on the lever and ensure that
the top of the lever lies fully in the switch channel
g005324
(Figure 10). If the top of the lever is not in the
switch channel, your machine will not start!
6
Figure 8
9).
Figure 9
g005308
g005309