Starting The Engine - Toro 20899 Manuel De L'utilisateur

immediately and contact an Authorized Service
Dealer.
•
Keep bystanders, especially small children, out of
the operating area. Stop the machine if anyone
enters the area.
•
Always look down and behind you before moving
the machine in reverse.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lighting.
•
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Avoid mowing in
wet conditions.
•
Use extreme care when approaching blind
corners, shrubs, trees, or other objects that may
block your view.
•
Watch for holes, ruts, bumps, rocks, or other
hidden objects. Uneven terrain could cause the
machine to overturn or cause you to lose your
balance or footing.
•
If the machine strikes an object or starts to vibrate,
immediately shut off the engine, remove the key
(if equipped), wait for all moving parts to stop, and
disconnect the wire from the spark plug before
examining the machine for damage. Make all
necessary repairs before resuming operation.
•
Before leaving the operating position, shut off
the engine, remove the ignition key (electric-start
model only), and wait for all moving parts to stop.
•
If the engine has been running the muffler will be
hot and can severely burn you. Keep away from
the hot muffler.
•
Check the grass catcher components and
the discharge chute frequently for any wear
or deterioration and replace them with the
manufacturer's recommended parts when
necessary.
•
Use accessories and attachments approved by
Exmark Mfg. Co., Inc. only.
Slope Safety
•
Mow across the face of slopes; never up and
down. Use extreme caution when changing
direction on slopes.
•
Do not mow on excessively steep slopes. Poor
footing could cause a slip-and-fall accident.
•
Mow with caution near drop-offs, ditches, or
embankments.

Starting the Engine

Important:
The machine has a safety switch that
prevents you from starting the machine unless
you first install the mulch plug or the grass bag
securely on the machine.
1. Install the mulch plug
bag (Figure 22) on the machine.
2. Turn the fuel valve lever to the O
(Figure 23).
3. Pull and hold the blade-control bar to the handle
and pull the recoil-start handle
11
(Figure 21) or the grass
Figure 21
Figure 22
position
N
Figure 23
(Figure 24).
g005309
g010266
g002896