Folding The Handle - Toro 20899 Manuel De L'utilisateur

1. Lower the machine to its lowest cutting-height
setting.
2. Move the machine onto a paved level surface.
3. With the engine running and the blade engaged,
spray a stream of water in front of the right, rear
wheel (Figure 35).
Note:
The water will splash into the path of the
blade, cleaning out the clippings.
4. When no more clippings come out, stop the
water and move the machine to a dry area.
5. Run the engine for a few minutes to dry the
underside of the machine.

Folding the Handle

Upright Position
1. Step on the foot pedal and hold it down
36).
2. Move the handle to the upright position
37).
Figure 35
Figure 36
g002600
Forward Position
1. With the handle in the upright position, step on
the foot pedal and hold it down.
2. Move the handle all the way forward and loosen
the upper handle knob
(Figure
3. To unfold the handle, refer to
Handle (page
g002773
(Figure
16
Figure 37
(Figure 38).
Figure 38
1 Unfolding the
4).
g020809
g010273