GB
IE
Replacing carbon brushes
Switch the device off and remove
the mains plug. Allow the device to
cool down.
1. Loosen the service panel (6) with
a screwdriver.
2. Remove the service panel (6).
3. Pull the carbon brush (10) out of
the holder.
4. Slide a new carbon brush (10)
into the holder.
5. Re-attach the service panel (6).
6. Repeat steps 1 to 5 on the other
side of the tool.
Carbon brushes must only be re-
placed in pairs.
Replacement parts/accessories
Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone
(see "Service-Center" Page 24). Please have the order number mentioned below ready.
Spare carbon brushes ............................................................................. 91104351
Socket set: 4 sockets
(17mm, 19mm, 21mm, 22mm) ............................................................. 91104352
Socket set:
10 sockets
(10mm,12mm,13mm,16mm,17mm, 18mm, 19mm, 21mm, 22mm, 24mm) 91104353
22
All manuals and user guides at all-guides.com
www.grizzly-service.eu
Storage
•
Clean the device prior to storage.
•
Store the device in the storage case
9) provided in a dry place and out
(
of reach of children.
Disposal and protection
of the environment
Take the device, accessories and packag-
ing for environmentally friendly recycling.
Machines do not belong with
domestic waste.
•
Return the unit to a recycling centre.
The plastics and metals in the unit can
be sorted and appropriately recycled.
Ask our Service Centre for details.
•
Defective units returned to us will be
disposed of for free.