Working Instructions; Cleaning And Maintenance; Cleaning - Parkside PDSSE 450 C3 Traduction Des Instructions D'origine

All manuals and user guides at all-guides.com
1. Press the on/off switch (3). The
device runs at the maximum
speed.
2. To turn it off, release the on/off
switch (3).

Working Instructions

•
The tightening torque depends on the
selected speed and impact duration.
• Use the electric impact wrench when
tightening screws and nuts exclusively
for pre-assembly. The desired target
torque of the screw or nut is not to be
achieved by the electric impact wrench
but by means of a torque wrench which
is set to the target torque.
• The tightening torque actually achieved
must be checked in all cases with a
torque wrench.
• When using the device for longer pe-
riods of time, allow the device to run
for 10 seconds without any load every
now and then.
• In order to achieve optimum impact
force, do not exert any pressure against
the screw/nut.
Always follow the manufacturer's
instructions for tightening screws
or nuts. Follow the manufacturer's
guidelines for the inspection of
screws or nuts in accordance with
time or performance.
After a wheel change is carried
out, reference is regularly made to
an inspection of the wheel bolts or
nuts. That inspection must be car-
ried out with a torque wrench after
50 to 100 km.
Attach extension
(optional)
1. Push the desired extension (*) (not
included in package) onto the tool
holder (1).
2. Push the desired socket (11-14)
onto the extension (*).
3. To remove it, pull the socket away
from the extension (*).
Cleaning and
maintenance
Disconnect the plug before any work
on the equipment. There is a risk of
injury.
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM parts.
Risk of injury!
The following cleaning and servicing should
be done regularly. This will ensure a long
and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots (
motor housing (
of the appliance. Use a damp cloth or a
brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably damage
the appliance.
GB IE
4),
2) and handle ( 7)
21