Optelec ClearView C Mode D'emploi page 23

Optelec
4.3.4. Activating the ClearView C Menu
to chapter 5.
4.3.5. Switching between the ClearView C and a computer / external
source image
To display the computer image on your ClearView C monitor correctly, make
sure that your computer's resolution is set to 1920 x 1080.
4.3.6. Auto-focus lock
auto-focus mode. Pressing the Auto-focus button marked with a dot and a
pencil icon (most right button) stops the ClearView C from continuously
operating the auto-focus feature and fixes the focus on the object being viewed.
This can be useful for writing, painting or crafts. When the auto-focus feature
is disabled, an icon with a pencil will be displayed. To enable the auto-focus,
simply press the Auto-focus button and the icon will disappear to indicate the
auto-focus is switched on again.
4.4. The Control Pad Batteries
The ClearView C Control Pad is powered by two coin cell batteries of the type
CR2025. These batteries last for two to three years. If the Control Pad buttons
stop functioning, and the ClearView C is more than two years old, or it is more
than two years ago that the batteries of the Control Pad have been changed,
please change the batteries. To change the batteries, gently open the battery
tray on the side of the Control Pad and replace the two batteries.
English
Press the blue Menu button in the middle, marked with the
word "Menu" to activate the ClearView C settings menu. For
more information about the ClearView C menu, please refer
If a computer or another external source is connected to the
ClearView C, press the gray PC button marked with an
arrow (second button from the right) to toggle between the
ClearView C image and the full screen computer image.
The ClearView C features an automatic focus camera that
produces a sharp on-screen image at any time. When
switching the ClearView C on, the system will start up in the
ClearView C
23