Optelec ClearView C Mode D'emploi page 21

Optelec
4.2.4. Object lighting On/Off
4.2.5. Overview function (position locator)
to indicate the center of the screen. Position the text you wish to read in the
crosshair's target by moving the reading table. Once the document has been
positioned, press the button once again to zoom in on the selected text in your
previous magnification setting.
4.2.6. Pointer (position locator)
light. After 30 seconds, the pointer will automatically be deactivated.
4.2.7. Reading table brake and friction control
Use the two sliders at the front of the reading table to apply friction to the left /
right direction or up / down direction movement or to lock the left / right or up /
down direction. When the sliders are positioned towards the outer left and right
edge of the table, the table can move freely up, down, left and right. To apply
more friction, move the sliders towards the center of the table, whereby the left
slider adjusts the friction in the left / right direction, while the right slider adjusts
the friction in the up / down direction. To apply maximum friction to the left /
right movement, slide the left slider to the center of the table. Alternatively, to
apply the maximum friction to the up / down movement, slide the right slider to
the center position. Adjusting the friction or locking the table can be useful when
writing, painting, doing hobbies and crafts, moving the ClearView C, or when
you are not using the ClearView C.
English
Pressing the white Mode button for four seconds turns off
the object lighting. You may want to temporarily turn of the
object lighting to eliminate light reflections. If you press this
button again, you will continue to the next reading mode and
the lights will turn back on. Pressing the button for four
seconds will turn the object lighting back on but will not
advance to the next reading mode.
The overview function provides you with a quick overview
of the text, which helps you to easily locate the part of a
document which is of interest.
Press the blue square Overview button to activate the
overview function. When the overview function is activated,
the ClearView C will automatically zoom out to the
minimum magnification, and will display a crosshair target
Pressing the blue square Overview button for three
seconds will activate a red LED light, which shows as a red
spotlight on the reading table. The pointer helps you locate
where the camera looks on the table. For instance: when
writing, place your pen in the red spotlight on the reading
table and the pen will be displayed in the center of your
screen. Press this button once again to deactivate the LED
ClearView C
21