Optelec ClearView C Mode D'emploi page 18

Optelec
3.2. Getting to know your ClearView C Flex
The following figures show the ClearView C Flex's main components.
1. Monitor
2. Reading table (optional)
3. Control Pad
4. X & Y Brake slides
5. Master power switch
6. Camera Box
3.3. Unpacking and installing the ClearView C Flex
The ClearView C Flex is shipped in boxes and needs to be assembled before
it can be used. Please also refer to ClearView C Flex Setup and Use
included in the box.
To set up and power on the ClearView C Flex, please take the following
steps:
1. Unpack the boxes of the ClearView C Flex.
2. Mount the bottom part of the ClearView C Flex on a stable table and
fasten it with the screw.
3. Place the top part of the ClearView C Flex on the bottom part.
4. In case the Clearview C Flex is used with the reading table, mount the
arm at the top of the pole, in its highest position.
5. Use the included Allen keys to tighten the screws at the top and bottom
part of the arm.
6. Mount the display adjustment.
7. Place the monitor on the display adjustment.
8. Slide the camera box into its position at the end of the arm.
9. If the camera does not look straight down onto the table surface, adjust
the viewing angle using the adjustment screw on top of the camera box
holder.
10. Insert the cables.
11. Plug the power cord into the power socket.
12. If the ClearView C Flex does not power on immediately, press the On /
Off button at the left side of the Electronic Box.
18
7. HDMI out
8. HDMI in
9. Power in
10. Power out
11. Camera connection (speech)
ClearView C
English