Items Supplied; How To Use - SilverCrest SSMP 900 B1 Mode D'emploi

WARNING! Risk of material
damage
Do not use the blade attachment with a
flat blade for liquids!
Thick or firm peels, (e.g. of citrus fruits,
pineapple), stems and pips of stone
fruits (e.g. cherries, peaches, apricots)
must be removed before blending.
Do not put any ingredients with a tem-
perature in excess of 85 °C into the
blender jug.
In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if the blades of the blade
attachment rotate with difficulty or not at
all. Pull out the mains plug and investi-
gate whether there is an obstruction in
the blender jug or whether the contents
are too viscous. Also check whether the
device is assembled correctly.
Do not operate the device with empty
blender jugs, as this causes the motor to
overheat and may result in it being
damaged.
Only operate the device when a blade
attachment is screwed onto the blender
jug.
The device is designed for a maximum
operating time of 60 seconds without in-
terruption. After this, the device must re-
main switched off until it has cooled
down to room temperature.
Only use the original accessories.
The device (base unit, power cable with
mains plug) is not dishwasher-safe.
Do not use any astringent or abrasive
cleaning agents.
6
GB
The device is fitted with non-slip plastic
suction feet. As furniture is coated with
a wide array of varnishes and synthet-
ics, and is also treated with different
care products, it cannot be fully ruled
out that some of these materials contain
ingredients that could attack and soften
the non-slip plastic suction feet. If neces-
sary, place a non-slip mat under the de-
vice.

4. Items supplied

1 base unit 1
1 blender jug large 5 (max. 700 ml)
2 blender jugs small 6 (max. 350 ml)
1 blade attachment 7 (cross blade)
1 blade attachment 8 (flat blade)
3 To Go lids 9
1 recipe book 13
1 copy of the user instructions
Unpacking
1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.

5. How to use

• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
• Clean the device prior to its first
use! (see "Cleaning" on page 9)
• Unwind the desired length of cable from
the cable spool 3 on the underside of
the device.
• Place the device on a dry, level, non-slip
surface.