Items Supplied; How To Use; Assembly - SilverCrest SSDMD 600 A1 KAT Mode D'emploi

fruits (e.g. cherries, peaches, apricots)
must be removed before blending.
In order to avoid damage to the device,
interrupt the blending process immedi-
ately if the blades of the blade assembly
do not turn at all or only with difficulty.
Pull out the mains plug and investigate
whether there is an obstruction in the
blender jug or whether the contents are
too tough. Also check whether the de-
vice is assembled correctly.
Never mix food on an oil basis such as
poppy seed or nuts (for instance for
poppy seed or nut butter) for more than
60 seconds, since otherwise the motor
may overheat and can be damaged.
Do not operate the device when it is
empty, as this causes the motor to over-
heat and may result in it being dam-
aged.
The device is designed for a maximum
operating period of 3 minutes without
interruption.
After this, the device must remain
switched off until it has cooled down to
room temperature.
Only use the original accessories.
All parts except for the motor block are
dishwasher-safe up to 70 °C.
Do not use any astringent or abrasive
cleaning agents.
The device is fitted with non-slip plastic
suction feet. As furniture is coated with
a wide array of varnishes and synthet-
ics, and is also treated with different
care products, it cannot be fully ruled
out that some of these materials contain
ingredients that could attack and soften
the non-slip plastic suction feet. If neces-
sary, place a non-slip mat under the de-
vice.
20 GB

4. Items supplied

1 blender jug 4
(filling volume min. 250 ml - max.1750 ml)
1 motor block 7
1 lid 2
1 measuring jug (30, 45, 60 ml) 1
1 copy of the user instructions

5. How to use

• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
• Clean the device prior to its first
use! (see "Cleaning" on page 22)
• Place the device on a dry, level and
non-slip surface.

6. Assembly

DANGER! Risk of injury from
cutting!
The blade assembly 6 is sharp. Handle
it with care.
Do not insert the mains plug 10 into a
wall socket until the jug blender has
been completely assembled.
NOTES:
• The device is equipped with two safe-
ty switches 3 / 8 and must be locked
twice. The device can only be put into
operation when the blender jug 4 and
the lid 2 are in position and locked.
Should it be possible to switch on the
device also without the blender jug 4 in
place, do not operate the device any
longer. Contact our Service Centre by
telephone or email (see "Warranty
of the HOYER Handel GmbH").
• If the blender jug 4 is removed during
operation, the device will switch off auto-
matically. Adjust the control dial 9 so
that the marking is pointing to 0 in order
to switch off the device before placing