Cleaning All Parts Of The Device; Storage - SilverCrest SSDMD 600 A1 KAT Mode D'emploi

8.2 Cleaning all parts of the
device
DANGER! Risk of electric
shock!
The motor block 7, the power cable
and the mains plug 10 must not be im-
mersed in water or any other liquids.
DANGER! Risk of injury from
cutting!
The blades of the blade assembly 6 are
sharp. Please be very careful when han-
dling them.
For manual cleaning, the water should
be sufficiently clear so that you can see
the blade assembly 6 easily.
WARNING! Risk of material dam-
age!
Do not use any astringent or abrasive
cleaning agents.
All parts except for the motor block 7
are dishwasher-safe up to 70 °C.
1. If necessary, disconnect the mains
plug 10 from the wall socket.
2. Remove the blender jug 4 from the mo-
tor block 7.
3. Remove the lid 2 from the blender
jug 4.
The motor block 7 must not be im-
mersed in water.
4. If necessary, wipe down the motor
block 7 and the power cable 10 with
a damp cloth. Ensure that the motor
block 7 is completely dry before the
next time it is used.
5. Clean the other parts of the device with
detergent and warm water. The follow-
ing parts are dishwasher-safe up to
70 °C:
- Blender jug 4
- Lid 2
- Measuring jug 1
6. Allow all parts to dry completely before
you put them away or use the device
again.
Some cleaning tips
• Clean the device as soon as possible af-
ter use in order to prevent food rem-
nants from drying on.
• After processing very salty or acidic
types of food, you should immediately
rinse the blender jug 4 thoroughly.

9. Storage

DANGER for children!
Keep the device out of the reach of chil-
dren.
DANGER!
In order to avoid accidents, the mains
plug 10 must never be connected to a
wall socket while in storage.
• Assemble the jug blender for storage
purposes.
• Select a location where neither high
temperatures nor moisture can affect the
device.
• Figure A: fully wind the power ca-
ble 10 on to the cable spool 11.
23
GB