Chopping; Remove Food; Cleaning; Instant Cleaning Of The Blender Jug - SilverCrest SSDMD 600 A1 KAT Mode D'emploi

7.2 Chopping

• To chop up food, turn the control dial 9
to the desired speed between the mark-
ings 1 and 5.
• To ensure safety, hold the device tightly
by the closed lid 2 during operation.
• Ingredients and liquids can also be add-
ed during operation via the refill open-
ing of the lid 2.
Harder food and crushed ice
NOTES:
• Only a maximum of 200 g of nuts may
be chopped up.
• Due to their exceptional hardness nut-
megs may not be chopped.
1. Fill food into the blender jug 4.
2. For chopping up harder food, repeat-
edly turn the control dial shortly to the
left to P. The number and length of the
pulses, which will be required to
achieve the desired consistency, will
depend on the quantity and consisten-
cy of the food.

7.3 Remove food

NOTE: do not store foodstuffs in the blender
jug 4 or in contact with other product parts
for longer than 24 hours. This also applies
to storage in the refrigerator.
1. Turn the control dial 9 until the marking
stripe points to 0.
2. Once the motor has come to a com-
plete standstill, remove the blender
jug 4 from the motor block 7.
To do this, turn the arrow
bol and then lift the blender jug 4
straight up.
3. To unlock, turn the lid 2 anticlockwise
and then lift it upwards.
4. Empty the blender jug 4.
22 GB
5. Clean the device as soon as possible
after use.

8. Cleaning

Clean the device prior to its first use!
8.1 Instant cleaning of the
blender jug
1. Figure B: place the blender jug 4 on
the motor block 7. The arrow
point to the
the blender jug.
2. Fill some warm water and detergent
into the blender jug 4.
3. Figure B: close the blender jug 4 with
the lid 2.
4. Figure B: turn the lid 2 fully into the
handle 5 in order to firmly connect it to
the blender jug and close the safety de-
vice 3.
5. If necessary, turn the marker stripe of
the control dial 9 to 0.
6. Insert the measuring jug 1 into the
lid 2 and lock it by turning it clockwise.
7. Figure B: lock the blender jug 4 by
rotating through a short distance. The
arrow
jug points to the
8. Insert the mains plug 10 into a wall
socket corresponding to the technical
data.
9. Rotate the control dial 9 several times
for a few seconds to the left to P and
then release it.
10. Disconnect the mains plug 10 from the
wall socket.
11. Once the motor has come to a com-
plete standstill, remove the blender
to the sym-
jug 4 from the motor block 7. Lift the
blender jug 4 vertically upwards.
12. Remove the lid 2 from the blender
jug 4.
13. Empty the blender jug 4 and rinse it
with clean water.
symbol at the bottom of
at the bottom of the blender
symbol.
must