Mixing/Chopping; Drink Immediately; Storage; Overheating Protection - SilverCrest SSMP 900 B1 Mode D'emploi

6.3 Mixing/Chopping

CAUTION:
Mind the marking MAX for the maxi-
mum filling quantity.
Depending on the hardness and consist-
ency of the ingredients in the blender
jug 5/6, do not fill it to the maximum;
otherwise the blade attachment 7/8
could become clogged.
NOTE: if the smoothie is too thick, add a lit-
tle mineral water, fruit juice, milk or yoghurt
to suit your taste.
1. Place the fruit pieces and any other in-
gredients into the blender jug 5/6 as
desired. Mind the marking MAX for
the maximum filling quantity.
2. Figure A: screw the required blade at-
tachment 7/8 onto the blender jug 5/6.
Ensure that the blade attachment is tightly
screwed to the blender jug.
3. Figure B: turn the blender jug 5/6
around and place it on the base unit 1.
The small noses 12 on the edge of the
blender jug fit into the recesses at the
head of the base unit 1.
4. Connect the mains plug 4 with the wall
socket.
5. A slight clockwise turn of the blender
jug 5/6 switches the device on.
Let the device run for no more than
60 seconds.
6. A slight anticlockwise turn of the blend-
er jug 5/6 switches the device off.
Wait until the blade 7/8 has come to a
standstill.
7. Remove the blender jug 5/6 from the
base unit 1 and turn it around.
8. Unscrew the blade attachment 7/8
and ensure that the liquid drips into the
blender jug 5/6.
9. Before using it again and if necessary,
rinse the blade attachment 7/8 briefly
under running water.
8
GB
10. Disconnect the mains plug 4 from the
wall socket.
11. Clean the device as soon as possible
after use.

6.4 Drink immediately

• Figure C: in order to drink the fresh
smoothie directly from the blender
jug 5/6, screw a To Go lid 9 on the
filled jug 5/6. Open the drinking clo-
sure 11 and drink from the opening for
drinking 10. After you have closed the
drinking closure 11 the opening for
drinking 10 and blender jug 5/6 are
tightly closed. You can also enjoy your
smoothie "to go" when you are out and
about.

6.5 Storage

• Figure C: smoothies are intended to be
consumed as soon as possible. For
short-term storage, screw a To Go lid 9
on the filled blender jug 5/6. Close the
drinking closure 11 if necessary. Then,
it is best to put the smoothie in the refrig-
erator.

6.6 Overheating protection

The device has an overheating protection
system. If the device has been in operation
for too long thus causing the device to be-
come too hot, it automatically switches off.
• In this case, pull out the mains plug and
allow the device to cool.
• You may then put the device back into
operation.