Cleaning The Motor Unit; After Cleaning; Storage; Appendix - SilverCrest SSM 550 D1 Mode D'emploi

Cleaning the motor unit

1) Use a soft dry cloth (or a lightly moistened cloth) to clean the surface of the
product.
2) After each cleaning, check that the contact switch in the attachment for the
blender attachment
remove the blockage with the corner of a piece of paper, then please contact
our customer service department. Do not use any hard objects as they can
damage the contact switch.
3) Remove any contamination from the underside of the motor unit
a dry cloth or a dust brush. Ensure that nothing can get into the appliance
through the ventilation openings.

After cleaning

Allow all parts to dry thoroughly before reassembling the blender and using it
again.

Storage

1) If you plan not to use the appliance for a long period of time, clean it thor-
oughly (see section "Cleaning").
2) Wrap the mains cable
the motor unit
3) Store the blender in a cool, dry location.

Appendix

Disposal of the device

Never dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of European Directive
2012/19/EU.
Dispose of the appliance via an approved disposal company or your municipal
waste facility. Please comply with all applicable regulations. Please contact your
waste disposal centre if you are in any doubt.
SSM 550 D1
is not blocked by dirt residues. If you are unable to
around the power cable retainer
.
only with
on the base of
│
GB 69 ■