SilverCrest SSM 550 D1 Mode D'emploi page 71

Masquer les pouces Voir aussi pour SSM 550 D1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If you clean the blender directly after use, you will usually achieve suitably
hygienic cleaning results by using the following method:
1) Fill the blender attachment
ing up liquid. Close the lid
motor unit
2) Plug in the appliance and activate Ice Crush/Clean a couple of times so that
the cutting blades
3) Afterwards, rinse the blender attachment
remove any washing up liquid residues.
If this does not remove the dirt, you
can remove the lower plastic part of the
blender attachment
blades
from the glass part of the
blender attachment
68
 GB
.
plough through the water at maximum speed.
with the cutting
:
with 750 ml of water and add a drop of wash-
and place the blender attachment
with plenty of clear water to
Glass part
Sealing ring
Cutting blade
Plastic part
4) Remove the blender attachment
from the motor unit
5) Turn the plastic part
attachment
can be removed from the glass part
of the blender attachment
WARNING –
RISK OF INJURY!
Treat the cutting blades
great care. They are extremely sharp!
Risk of injury!
6) Clean both parts in a mild soap solu-
tion or in the dishwasher.
7) Re-attach the plastic part
blender attachment
of the blender attachment
sure the sealing ring
onto the
.
of the blender
anticlockwise so that it
.
/
with
of the
to the glass part
. Make
is inserted.
SSM 550 D1

Publicité

Table des Matières
loading

Table des Matières