Filling During Operation; Removing The Blender Attachment - SilverCrest SSM 550 D1 Mode D'emploi

NOTE
► Do not fill the blender attachment
Otherwise, the appliance will not crush the ice cubes optimally.

Filling during operation

► Never insert cutlery items or mixing tools into the blender attachment
when the appliance is in use. There is a considerable risk of injury if these
come into contact with the swiftly rotating cutting blades
► Do not open the lid
NOTE
► If you want to add a little extra while the appliance is running, use only the
measuring cap
To add food while the appliance is running...
1) Turn the measuring cap
2) Add the ingredients.
3) Then replace the measuring cap
turning it clockwise.

Removing the blender attachment

Once you have finished processing the food in the attachment:
■ Always start by placing the switch
the mains plug.
■ Wait until the motor has come to a complete standstill before lifting the blender
attachment
ment
■ To achieve the best results when pureeing solid ingredients, add only small
portions to the blender attachment
■ If you are working with solid foods, cut them into small pieces (2–3 cm).
■ When mixing liquid ingredients, start by adding small quantities of liquid.
Add further liquid as required through the opening in the lid.
SSM 550 D1
WARNING – RISK OF INJURY!
. Food could fly out at high speed!
provided for this purpose.
directly upwards. You do not need to turn the blender attach-
while doing this.
with more than 180 g of ice cubes.
anticlockwise and remove it.
in the opening in the lid and close it by
into the "OFF" position and pulling out
instead of a large amount at once.
!
│
GB 63 ■