Cleaning The Motor Block; After Cleaning; Storage - SilverCrest SSM 550 D1 Mode D'emploi

GB
IE
3) Clean both parts thoroughly in a mild soapy solution or in a dishwasher.
4) Refit the plastic element

Cleaning the motor block

1) Use a dry or no more than slightly moistened cloth to clean the plastic
2) When cleaning, always check that the contact switch in the fitting for the
3) Remove any possible residues on the underside of the motor block

After cleaning

Allow all parts to dry well before reassembling and reusing the liquidiser.

Storage

1) If you do not intend to use the blender for an extended period, clean it
2) Wrap the power cable
3) Store the blender in a cool and dry location.
14
All manuals and user guides at all-guides.com
WARNING! RISK OF INJURY!
► Take care with the cutting blades
Ensure that the sealing ring
surfaces.
blender is not blocked by soiling residues. If you cannot dislodge any
blockages with the corner of a piece of paper, make contact with Customer
Services. Do not use any hard objects, these could damage the contact
switch.
dry cloth or a stiff-bristled brush only. Ensure that nothing can get in through
the ventilation openings of the appliance.
thoroughly (see chapter "Cleaning").
motor block .
. They are very sharp. Risk of injury!
of the blender onto the glass element
is correctly fitted.
around the cable retainer
.
with a
on the base of the
SSM 550 D1