Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB_103371_Smoothie_Mixer.fm Seite 37 Dienstag, 25. November 2014 6:46 18
3. Turn the blender jug as far as it will go in
a clockwise direction, until the marking|9
points to the closed lock|5.
4. Connect the mains plug|7 with the wall
socket.
5. Figure A: pivot the blender jug with
the motor unit|1 into its maximum up-
ward position.
6. Press and hold the mix button|2. The
blending process is started.
7. Release the mix button|2 after approx.
10 - 20 seconds. The blending process
is thereby completed.
8. Figure B: pivot the blender jug with
the motor unit into its fully downwards
position.
9. Wait until the drink has collected in the
blender jug|6 .
10. Turn the blender jug anti-clockwise until
the marking|9 points to the opened
lock|5.
11. Pull the blender jug downwards to re-
lease it from the blade assembly|4. To
remove the large blender jug, first pivot
the motor unit slightly upwards.
12. If there are still rather large pieces of
fruit in the smoothie, repeat the blend-
ing process for a few seconds.
13. If necessary, close the blender jug with
the lid|11.
14. Clean the device with the cleaning
jug|8 as soon as possible after use.
15. Disconnect the mains plug|7 from the
wall socket.
7. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric shock!
~ Pull out the mains plug|7 from the wall
socket before cleaning the Smoothie
Blender.
~ The motor unit|1, the housing|3, the pow-
er cable and the mains plug|7 must not
be immersed in water or other liquids.
DANGER! Risk of injury from
cutting!
When washing manually, the water should
be sufficiently clear for you to see the blade
assembly|4 easily.
WARNING! Risk of material damage!
Do not use any astringent or abrasive clean-
ing agents.
NOTE:
The following parts can be cleaned in the
dish washer:
-
the blender jug|6/8 and its lid|11,
-
the spill tray|12.
After every use
Preferably clean the device after each use
and remove all food residues from the blade
assembly.
1. Fill the cleaning jug|8 with clear water
and, if necessary, a little detergent.
Then rinse with clear water.
2. Operate the device as described
(Chapter "Operation" on page 36).
3. Disconnect the mains plug|7 from the
wall socket.
4. Pivot the motor unit|1 upwards. If there
are still bit of food (e.g. fruit cores) on
the sealing ring|14, wipe it down with
kitchen roll in order to ensure its seal-
ing function. If necessary, perform an
intensive cleaning (see below).
5. Wipe the housing|3, motor unit|1 and
the power cable|7 with a damp cloth if
necessary. Dry with a dry cloth.
6. The rest of the parts can be cleaned
with warm water and some detergent.
7. Allow all parts to dry completely before
you put them away or use the device
again.
Intensive cleaning
If food residues can no longer be removed
by using the cleaning blender jug, the blade
assembly should be removed from the de-
vice and should be cleaned separately.
37
GB
Publicité
Table des Matières
