How To Use; Operation - SilverCrest SSM 175 B2 Mode D'emploi

__RP103371_B2.book Seite 36 Freitag, 21. November 2014 1:02 13

5. How to use

• Remove all packing material.
• Check to ensure that all parts are pre-
sent and undamaged.
• Clean the device prior to its first
use! (see "Cleaning" on page 37)
• Place the device on a dry, level, non-slip
surface.

6. Operation

DANGER! Risk of electric
shock! Only plug the mains plug|7
into the wall socket when the Smooth-
ie Blender is completely assembled.
DANGER! Risk of injury from
cutting!
~ Under no circumstances should the de-
vice be operated without the blender
jug|6.
~ The blades of the blade assembly|4 are
sharp. Handle it with care.
~ The blades of the blade assembly carry
on rotating after the device has been
switched off. Wait until the blades have
come to a standstill before you remove
the blender jug.
WARNING! In order to prevent damage to
the device, interrupt the blending process
immediately if the blades of the blade as-
sembly|4 rotate with difficulty or not at all.
In this case, pull out the mains plug|7 and
check whether there is an obstruction in the
blender jug|6.
Application area
The Smoothie Blender is intended solely for
blending of whole fruit drinks (smoothies).
36 GB
Preparing food
WARNING! Risk of material
damage!
Thick or firm peels, (e.g. of citrus fruits, pine-
apple), stems and pips of stone fruits (e.g.
cherries, peaches, apricots) must be removed
before blending.
• Rinse or wash the fruits.
• Cut the fruit into rough pieces (approx.
3-4 cm edge length).
• Please use a sufficient amount of liquid
(mineral water, fruit juice, milk, yoghurt).
We recommend a mixing ratio of 1:1.
Blending
CAUTION: depending on the hardness
and consistency of the ingredients in the
blender jug|6, do not fill it to the maximum;
otherwise the blade assembly|4 could be-
come clogged.
NOTES:
• If the smoothie is too thick, add a little
mineral water, fruit juice, milk or yo-
ghurt to suit your taste.
• You may achieve a more even consisten-
cy for the smoothie (e. g. when using
harder fruits), if you repeatedly interrupt
and restart the blending process (pulse
function: release and then press the mix
button|2 again).
• If there are still bit of food (e.g. fruit
cores) on the sealing ring|14, wipe it
down with kitchen roll in order to ensure
its sealing function.
1. Place the fruit pieces and other ingredi-
ents into the blender jug|6 as desired.
2. Figure C: stick the blender jug into the
preassembled blade assembly|4 from
the bottom. The marking|9 points to-
wards the opened lock|5. The locking
blades|10 on the blender jug engage
into the recess at the blade insert.