Items Supplied; How To Use; Installation - SilverCrest SSMP 2000 A1 Mode D'emploi

BB&3(B%ERRN 6HLWH  0LWWZRFK  $SULO    
out the mains plug and investigate
whether there is an obstruction in the
blender jug or whether the contents are
too tough. Also check whether the de-
vice is assembled correctly.
~ Never mix food on an oil basis such as
poppy seed or nuts (for instance for
poppy seed or nut butter) for more than
60 seconds, since otherwise the motor
may overheat and can be damaged.
~ Do not operate the device when it is emp-
ty, as this causes the motor to overheat
and may result in it being damaged.
~ The device is designed for continuous
operation of ...
... no more than 1 minute without inter-
ruption at high speed (control dial
>3 - 6) and
... no more than 3 minutes without inter-
ruption at low speed (control dial 1 - 3).
After this, the device must remain
switched off until it has cooled down to
room temperature.
~ Only use the original accessories.
~ All parts except for the motor block are
dishwasher-safe up to 70 °C.
~ Do not use any astringent or abrasive
cleaning agents.
~ The device is fitted with non-slip plastic
bases. As furniture is coated with a
wide array of varnishes and synthetics,
and is also treated with different care
products, it cannot be fully ruled out that
some of these materials contain ingredi-
ents that could attack and soften the
non-slip plastic bases. If necessary,
place a non-slip mat under the device.

4. Items supplied

1 Blender jug|5 (maximum filling volume
2|litres)
1 Motor block|9
1 Lid|3
1 Measuring jug (30, 45, 60 ml)|2
1 Food pusher|1
1 Operating instructions

5. How to use

• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
• Clean the device prior to its first
use! (see "Cleaning" on page 51)
• Place the device on a dry, level and
non-slip surface.

6. Installation

DANGER! Risk of injury from
cutting!
~ The blade insert|7 is sharp. Handle it
with care.
~ Do not insert the mains plug|10 into a
wall socket until the jug blender is com-
pletely assembled.
NOTES:
• The device is equipped with two safety
switches. The device can only be oper-
ated with the blender jug|5 in place and
the lid|3 closed and locked with its safety
brackets|4. Should it be possible to
switch on the device also without the
blender jug|5 in place, do not operate
the device any longer. Contact our Ser-
vice Centre by telephone or email
(see "Warranty of the HOYER Handel
GmbH" on page 55).
• If the blender jug|5 is removed during
operation, the device will switch off au-
tomatically. Set the control dial|11 to 0
before placing the blender jug|5 on the
motor block|9.
1. Figure A: position the blender jug|5
on the motor block|9 so that the han-
dle|6 points to the right above the posi-
tion marking|8.
2. Fill the prepared foodstuffs into the
blender jug|5.
3. Close the blender jug|5 with the lid|3
such that the safety bracket|4 engages
audibly at the handle|6.
49
GB