Storage; Disposal; Trouble-Shooting - SilverCrest SSM 175 B2 Mode D'emploi

GB_103371_Smoothie_Mixer.fm Seite 38 Dienstag, 25. November 2014 6:46 18
1. Pull out the mains plug|7.
2. If necessary, pull the blender jug|6 anti-
clockwise and pull it down and off the
blade assembly|4.
3. Rotate the motor unit|1 right to the top
until it locks into place in this position.
4. Figure D: turn the rim of the blade as-
sembly|4 in a clockwise direction until
the arrow symbol shows to the opened
lock|13 and pull it up and off the mo-
tor unit|1.
5. Clean the blade assembly with warm
water and a little detergent.
6. Let the blade assembly dry completely.
7. Place the blade assembly|4 on the motor
unit|1. The arrow symbol shows to the
opened lock|13.
8. Turn the blade assembly until the arrow
symbol shows to the closed lock. The
blade assembly is now correctly mount-
ed again.

8. Storage

DANGER for children! Keep the
device out of the reach of children.
DANGER! In order to avoid accidents, the
mains plug|7 must never be connected to a
wall socket while in storage.
• Select a location where neither high
temperatures nor moisture can affect the
device.

9. Disposal

The symbol showing a wheel-
ie bin crossed through indi-
cates that the product requires
separate refuse collection in
the European Union. This ap-
plies to the product and all ac-
cessories marked with this symbol. Products
identified with this symbol may not be dis-
carded with normal household waste, but
38 GB
must be taken to a collection point for recy-
cling electric and electronic appliances. Recy-
cling helps to reduce the consumption of raw
materials and protect the environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.

10. Trouble-shooting

If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock! Do not attempt to repair the
device yourself under any circum-
stances.
Possible causes /
Fault
• Has the device been
connected to the pow-
er supply?
• Check the connection.
• Is the blade assem-
No function
bly|4 mounted proper-
ly?
• Has the blender jug|6
been engaged proper-
ly?
Blade assem- • Switch off immediate-
bly|4 is turning ly, pull out mains
with difficulty or plug|7 and check:
not at all Blockage in the vessel?
• Is the quantity of ingre-
Liquids are
dients filled into the
running out
blender jug too large?
Action