Cleaning The Motor Block; Storage - SilverCrest SSMC 600 B1 Guide De Démarrage Rapide

■ Dry all parts thoroughly before reusing or storing them.
■ If this does not remove the dirt, you can remove the lower plastic part of the
blender attachment with the cutting blades from the glass part of the blender:
1) Remove the blender from the motor unit. For better stability, remove the lid by
turning it anticlockwise towards position
2) Turn the appliance upside down and turn the plastic part of the blender
anticlockwise so that it can be detached from the glass part of the blender
attachment.
3) Clean both parts in a mild soap solution or in the dishwasher.
4) You can carefully remove the sealing ring from the plastic part if necessary.
Clean in mild soapy water and rinse with clear water.
5) Dry all parts thoroughly before reassembling them.
6) If necessary, reinsert the sealing ring into the plastic part correctly. Then
place the plastic part of the blender back on the glass part of the blender
and turn the plastic part clockwise.

Cleaning the motor block

■ If necessary, clean the motor unit and its mains cable with a damp cloth. For
stubborn stains, apply a mild detergent to the cloth and wipe off with a cloth
moistened only with water. Dry everything well afterwards.
■ When cleaning, always check that the contact switch in the fitting for the
blender is not blocked by soiling residues. If you cannot dislodge any
blockages with the corner of a piece of paper, make contact with Customer
Services. Do not use any hard objects, these could damage the contact
switch.

Storage

1) If you do not intend to use the blender for an extended period, clean it
thoroughly (see chapter "Cleaning").
2) Wrap the power cable around the cable retainer on the base of the motor
block.
3) Store the blender in a cool and dry location.
SSMC 600 B1
until you can pull it off upwards.
GB │ IE │
9 ■