Intended Use - Scheppach CCS165-20ProS Traduction Des Instructions D'origine

9. Avoid damage and impacts! Replace recharge-
able batteries immediately if these fall more than
one metre or if they have been exposed to hefty
impacts, even if the battery pack housing ap-
pears undamaged. The battery cells inside may
be seriously damaged. Also observe the disposal
instructions here.
10. With overloading or overheating, the protective
shut-down integrated in the device switches off
for safety reasons. Attention! Do not actuate the
on/off switch again if the protective shut-down
has switched the device off. This can lead to
damage to the rechargeable battery.
11. Only use original rechargeable batteries. The use
of other batteries can lead to injuries, explosion
and a risk of fire.
Warning! This electric tool generates an electro-
magnetic field during operation. This field can im-
pair active or passive medical implants under certain
conditions. In order to prevent the risk of serious
or deadly injuries, we recommend that persons with
medical implants consult with their physician and the
manufacturer of the medical implant prior to operat-
ing the electric tool
Information on the charging unit and charging
process
1. Observe the data provided on the type plate of
the charging unit. Only connect the charging unit
to the mains voltage provided on the type plate.
2. Protect the charging unit and cable from dam-
age and sharp edges. Have damaged cables re-
placed by an electrician immediately.
3. Keep the charging unit, rechargeable batteries
and rechargeable device out of reach of children.
4. Do not use damaged charging units.
5. Do not use the charging unit supplied to charge
other rechargeable devices.
6. The rechargeable battery pack will heat up with
heavy loads. Leave the rechargeable battery
pack to cool down before starting the charging
process.
7. Do not over-charge rechargeable batteries!
Observe the maximum charging times. These
charging times only apply to discharged bat-
teries. Inserting a charged or partially charged
rechargeable battery multiple times leads to
overloading and cell damage. Do not leave re-
chargeable batteries in the charging unit for mul-
tiple days.
8. Never use or charge rechargeable batteries if
you suspect that they were last charged more
than 12 months ago. The probability is high that
the rechargeable battery is already dangerously
damaged (deep discharge).
24 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
9. Charging at a temperature of less than 10°C
leads to chemical damage to the cell and can
result in a fire.
10. Do not use rechargeable batteries that have heat-
ed up during charging, because the battery cells
could be dangerously damaged.
11. Do not use rechargeable batteries that are bulg-
ing or deformed, or that exhibit unusual symp-
toms (out-gassing, hissing, crackling, etc.)
12. Do not discharge the rechargeable battery fully
(recommended final discharge level max. 80%).
Fully discharging leads to premature ageing of
the battery cells.
13. Never leave batteries to charge unsupervised!
Residual risks
The machine has been built according to the state of
the art and the recognised technical safety require-
ments. However, individual residual risks can arise
during operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the „safety in-
structions" and the „Proper use" are observed
along with the whole of the operating instructions.
• Avoid accidental starting of the machine. Use the
tool that is recommended in this manual. This en-
sures that your machine performs optimally.
• Hands may never enter the processing zone when
the machine is in operation.

8. Intended use

The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufactur-
er will be liable for any damage or injuries of any kind
caused as a result of this.
To use the equipment properly you must also observe
the safety information, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the equipment have
to be acquainted with this manual and must be in-
formed about the equipment's potential hazards.
It is also imperative to observe the accident preven-
tion regulations in force in your area.
The same applies for the general rules of health and
safety at work.
The manufacturer will not be liable for any changes
made to the equipment nor for any damage resulting
from such changes.
The machine may be used only with original acces-
sories and original tools of the manufacturer.