FAS International SKUDO Mode D'emploi page 80

30
9.2 SUBMENU FOR SETTING THE CLOCK & DAILY EVENT TIMERS (SEE COMMAND 02)
Alarm set 01 Sets the year/month/day:
This command is used to set the year, month and day on the clock in the control board. The introduction
format is YYMMDD.
Alarm set 02 Sets the hour and minute:
This command is for setting the hour and minute in the realtime clock built into the electronic control board.
Key in the exact time in hours and minutes and press the ENTER pushbutton to confirm the setting.
The following procedure will set the clock at 10.30:
1. Go into programming mode to display ................................................................................._Command 00_
2. Key in 02 and press the ENTER button to display...................................................................... _Alarm 00_
3. Key in 2 and press the ENTER button to display the hours and minutes previously set ............... _NNNN_
4. Key in 1030 and press the ENTER button.
Alarm set 03 Setting the days of the week:
E
This command is used to set the day on the clock which is present on the control board; the permissible
N
values are from 1 (Monday) to 7 (Sunday).
G
L
Alarm 11 NOT USED
I
S
Alarm 21 Setting discount time slots:
H
With these commands you can program 3 daily discount time slots. In the time slots with the discount active
the machine refers to the prices set in the submenu relevant to the discounted prices. Naturally command 62
in the main menu must be set at 1. If this function is not required, program 2400 in Alarm 21.
Alarm 31 Selections disabled for daily time periods:
These commands allow the selections set at command "Alarm 36" to be disabled for 3 time periods per day.
If use of this function is not required, programme 2400 at Alarm 31.
Alarm 36 Setting the selections with timed disabling :
Upon entry to the command the system asks the operator to disable the option that concerns the entire
machine including any slave machines that may be connected (option 1), or not (option 0). If option 0 is
selected, the command allows the operator to choose which selections must be disabled during the time
slots when the "selections disabled" function is enabled (see programming Alarms 31-34).
Example:
To activate the disabled time slot for selection 15 proceed as follows:
1. Programming mode, ......................................................................... Command 00 appears on the display
2. Type 02 and press B, .............................................................................Alarms 00 appears on the display
3. Type 36 and press B, , ...............................................................Select. number 00 appears on the display
4. Type 15 and press B, , ...................................................................... Dis./En.1/0 N appears on the display
5. Set the value 1 and press B.
N.B.: With SPIRALI SLAVE connection enabled (see command 49), once the settings for the MASTER
machine have been completed, access is gained to the setting mode for the same parameters relevant to
the SLAVE machine by simply pressing the A (ESC) button.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
SKUDO – Issue 00