Eurosystems Evo MLT03 Mode D'emploi page 25

GARAGING AND SCHEDULED MAINTENANCE (Fig. 16)
grassland mower, cutting bar , etc..) it should be positioned as shown in the picture. Please put under the engine the polystyrene (1) you can find
into the packaging or any other support showing a vertical side at least 14 cm. height. The a.m. operation avoids the oil to draw into the combustion
chamber . Please be very careful also when putting new oil into the engine and to the equipment assembly/disassembly.
ATTENTION! The used oil must not be drained into the sewer system or waterworks. In order to prevent any pollution to the water-table. Most garages
have used oil deposits, or use the authorized deposits according to your local authority regulations.
Keep attention that all the nuts, screws and bolts are tightened in order to guarantee a good machine working on safety conditions. Leave the machine
to cool before garaging anyhow don't room it if the tank still contains some fuel as the vapours could reach some blazes or sparks. The fuel tank is
to be drained outdoors only. To lower the fire danger, keep the engine, the silencer and the fuel area free from leaves, grass or greasy substances.
You are kindly requested to periodically verify from the inflation pressure level for the tires : the recommended value is 21 PSI (1,5 Bar). However
be careful not to exceed the maximum value indicated on the tire itself.
AIR NOISE AND VIBRATIONS
TROUBLESHOOTING
Before performing any maintenance and clearing work operation , please take the spark-plug cap off.!
FAULT
The engine does not start
The engine power goes down
In case you are not able to remedy the defect/damage according to a.m. table, please contact an authorized service center only .
Please read the accessories instruction booklet.
FAULT CLEARANCE
Check the fuel level, if necessary refuel.
Check the throttle to be on START position.
Check the spark-plug connector to be properly attacched.
Check the spark-plug condition and if necessary replace it.
Check the fuel valve to be in the opened position (only for the models showing
such feature).
The air filter is dirty – please clean it.
When the motor cultivator is stored without equipment ( like rotavator,
EN
25