What To Do If - Electrolux GA553IF Notice D'utilisation

Upper basket spray arm
1. To remove the upper basket spray arm,
turn it laterally.
2. Clean the spray arm.
3. To attach again the spray arm, press up-
wards until it goes back into position.
Lower spray arm
1. Turn the fixing screw B) counterclock-
wise.
2. Pull the spray arm off the shaft.

What to do if...

The appliance does not start or stops during
operation.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a sol-
ution to the problem yourself, contact the
Service Force Centre.
Fault code and malfunction
• continuous flash of the light of the
running programme
• 1 flash of the end-of-programme
indicator light
The dishwasher does not fill with wa-
ter
3. Clean the spray arm and the fixing screw.
4. Attach the spray arm with the fixing screw
by turn it clockwise.
External cleaning
Clean the external surfaces of the appliance
and control panel with a damp soft cloth.
Only use neutral detergents. Do not use
abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).
Frost precautions
Caution! Do not install the appliance
where the temperature is below 0 °C.
The manufacturer is not responsible for
damage because of frost.
If not possible, empty the appliance and
close the door. Disconnect the water inlet
hose and remove water from the water inlet
hose.
Caution! Switch off the appliance
before you do the below suggested
corrective actions.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the connection is correct.
electrolux 17