Installation - Electrolux GA553IF Notice D'utilisation

Water supply pressure
Capacity

Installation

Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Install the appliance under a counter (kitchen
worktop or sink).
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap and
a drain.
For the venting of the dishwasher only water
fill, water drain and power supply cable open-
ings are necessary.
Make sure that the water inlet hose, the drain
hose and the supply cable are not kinked or
squashed, when you insert the machine.
Attaching the appliance to the adjacent
units
Make sure that the counter below which you
attach the appliance is attached to a safe
structure (adjacent kitchen units, cabinets,
wall).
1. Set the appliance in front of the kitchen
unit. Put the mains cable and the hoses
into the recess unit.
2. Push the appliance in and pull the mains
cable and the hoses through. Make sure
that they are not kinked or squashed.
3. Align the appliance and attach it on the
two sides in the upper area of the tub.
Minimum
Maximum
Place settings
Other attaching possibilities
1. On the plinth.
2. Additional bracket on the top. This is
50
available as a special accessory. Contact
the Service Force Centre.
electrolux 19
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
11