Use Of The Appliance - Electrolux GA553IF Notice D'utilisation

1)
Salt
1) When the salt and/or rinse aid containers are empty, the related indicator lights do not come on while
a washing programme operates.
Programme button
With this button you can select the washing
programme. Press the button until the indi-
cator light of the necessary programme
comes on. Refer to 'Washing programmes'
chapter for more data about the washing
programmes.
Multitab button
Press this button to activate/deactivate the
multitab function. Refer to the chapter 'Mul-
titab function'.
Half-load button
Important! Set the Half-load option before
the start of a washing programme. You
cannot set the option when a washing
programme operates. If it is necessary to set
the Half-load option, cancel the washing
programme.
The Half-load option is not available for all
washing programmes. Refer to the chapter
'Washing programmes'.
• Load dishes in the upper and lower bas-
ket.
• Decrease the detergent dosage when you
use the Half-load option.
• Press the Half-load button to set the op-
tion.
– The Half-load indicator light comes on,
when the Half-load option is available.
With the Half-load option the time dura-
tion and the consumption of water and
energy are reduced.

Use of the appliance

Refer to the following instructions for each
step of procedure:
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
Indicator lights
The indicator light comes on when it is necessary
to fill the salt container. Refer to the chapter 'Use
of dishwasher salt'.
After you fill the container, the salt indicator light
can continue to stay on for some hours. This does
not have an unwanted effect on the operation of
the appliance.
Function buttons
Use the function buttons for these opera-
tions:
• To set the water softener. Refer to the
chapter 'Setting the water softener'.
• To deactivate/activate the rinse aid dis-
penser, when multitab function is active.
Refer to the chapter 'Multitab function'.
• To cancel the washing programme in pro-
gress.
Setting mode
Press the on/off button, if the programme
button indicator light and the end-of-pro-
gramme indicator light are on, the appliance
is in setting mode.
The appliance must be in setting mode for
these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the rinse aid dis-
penser.
Press the on/off button, the appliance is not
in setting mode if:
• the programme button indicator light is on,
• a programme indicator light is on,
• 1 or 2 phase indicator lights are on.
Cancel the programme to go back to the
setting mode. Refer to the chapter 'Setting
and starting a washing programme'.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.
electrolux 5