Frost Precautions; Moving The Machine; What To Do If - Electrolux AEG FAVORIT 35020 VI Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Frost precautions

Avoid placing the machine in a location where the temperature is below 0°C. If this is
unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe
and empty it.

Moving the machine

If you have to move the machine (moving house etc....):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge hoses.
4. Pull the machine out together with the hoses.
Avoid over tilting the machine during transportation.

What to do if...

The dishwasher will not start or stops during operation. Certain problems are due to the
lack of simple maintenance or oversights, which can be solved with the help of the indi-
cations described in the chart, without calling out an engineer.
Switch off the dishwasher and carry out the following suggested corrective actions.
Fault code and malfunction
• continuous flashing of the light of the run-
ning programme,
• 1 intermittent audible signal
• 1 flash of the end of programme indicator
light,
The dishwasher does not fill with water.
• continuous flashing of the light of the run-
ning programme,
• 2 intermittent audible signals
• 2 flashes of the end of programme indicator
light,
The dishwasher will not drain.
• continuous flashing of the light of the run-
ning programme,
• 3 intermittent audible signals
• 3 flashes of the end of programme indicator
light,
Anti-flood device is activated.
Possible cause and solution
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off. Turn the water tap
on.
• The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
• The water inlet hose has not been correctly
laid or it is bent or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly
laid or it is bent or squashed.
Check the water drain hose connection.
• Close the water tap and contact your local
Service Force Centre.
21
What to do if...

Publicité

Table des Matières
loading

Table des Matières