wallas 22 Dt Mode D'emploi page 75

D10141
22 Dt / 30 Dt / 40 Dt
Installation
Closable lead-through 2460
The cap of the closable lead-through must be detached for installation and seal
maintenance by pressing the spring indicated by the arrow in with, for instance, a
screwdriver. Take care not to let the screwdriver slip as the spring is very stiff. Hold
the cap with your other hand when pressing in the spring. When the spring is down,
pull the cap gently out of the frame. When assembling the lead-through, ensure
that the order of the parts is correct. Also make sure that the spring goes in the cor-
rect hole in the cap. Otherwise, the lead-through cannot be closed.
2460
Closable lead-through.
Maintenance
To keep the seals from hardening, lubricate
them yearly with a heat-resistant petroleum
jelly.
Check that closeable fitting is open before starting the device.
Package contents
2460
1 pcs Closable lead-through
1 pcs Spacing tube
1 pcs Accessory bag 17676
4 pcs
8 pcs
4 pcs
4 pcs
1 pcs
1 pcs
Seals
Fastening screw M5 x 85 mm
Nut M5
Washer 5,3 x 15 mm
Washer 5,3 x 10 mm
Hose binder 32 - 50 mm
Gasket
- 75 -
en
Cap
Frame
490526C