wallas 22 Dt Mode D'emploi page 62

D10091
22 Dt / 30 Dt / 40 Dt
Installation
Control panel installation
Cut a suitable installation hole for the control panel in the selected location. Try to
install the panel in a vertical surface in a location that will remain dry.
The thermostat sensor is in the panel face, so select the location with
thermostatic operation/regulation in mind. Do not install close to
heat source or close to a window or door. Avoid locations that might
be contacted by direct sunlight. The length of the control panel cable
is 6 m. A 10 meter cable 363058 is available as an accessory.
17,5 mm
( / '')
11
16
Measurements of the control panel installation cut-out.
If necessary, predrill holes for the ø 2 mm (
You can utilize the sample of the box when drawing the lines of the
installation hole.
104 mm (4
1
Connect the control panel cable from
the device to the control panel (1).
Use the fastening screws to install the
control panel to the installation cut-out
(2).
100 mm (3
65 mm (2
4,5 mm ( / '')
11
64
ø 2 mm ( / '')
3
32
/ '')
3
32
4
2
An extension collar (3) is used when control
panel is surface mounted.
The box of the panel includes 4 pcs screws 3,5
x 40mm (black) TX10 (4).
- 62 -
/ '')
15
16
/ '')
9
17,5 mm
16
(
11
/ ") screws.
3
32
3
en
/ '')
16
490526C