wallas 22 Dt Mode D'emploi page 63

WARM AIR
OUT
Accessories are connected to
the control panel, the image
shows the place.
Take care of the strain relief.
D10101
22 Dt / 30 Dt / 40 Dt
Installation
Connections of the device
Things to note about the connections
In installation, to make the mounting and demounting for service easier, it is recom-
mended to leave some extra length of loose cables and fuel line by creating a coil.
If the installation location is cramped, it is recommend to connect the cabels and
the fuel line to the device before mounting the unit to bracket. This will help the
installation of device.
EXHAUST
OUT
COMBUSTION AIR
IN
(22 Dt, 30 Dt)
Remote control (accessory)
Timer (accessory)
Solenoid valve
(accessory)
- 63 -
en
COLD AIR
IN
Use pliers to hold
the pump inlet elbow
steady, while you
tighten the 12 mm fuel
line nut!
490526C