Publicité
Les langues disponibles
Les langues disponibles
on frame size and shape). Now place the cuff over the rubber inlay and squeeze together firmly, in doing so,
make sure that the rubber inlay is not crushed or creased. Insert the lock screw through the two drilled holes
of the cuff. Gently rotating will tell you whether the square of the lock screw is seated firmly. Now place the
components on the lock screw in this order: Tube, spacer (with the curve facing the frame clip), frame clip,
spacer (with the curve facing the frame clip) and washer. Screw the knob nut into place by turning clockwise.
Replace the cover cap back on the cuff.
Laying electrical cables
Lay the cables along the tube of the rack plate. The cables may not be bent, stretched or crushed, e.g. in the
vicinity of the folding mechanism. Secure the cables with the supplied cable ties. When you are finished, trim
any excess material from the cable ties using cutting pliers.
Mounting the bicycle rack on the trailer tow bar
Adjustable bolt
Ensure that the trailer tow bar is undamaged, clean and free of grease.
Before you put the bicycle rack on the trailer tow bar, familiarise yourself with the quick locking system.
The quick locking mechanism is a component with a tension lever. Activating the tension lever opens or
closes the quick locking mechanism. With the help of the securing bolt and the padlock, the quick locking
system may be locked and secured.
The padlock is always required when using the bicycle rack.
Park your vehicle on a level surface. Apply the handbrake. Remove the securing bolt from the quick locking
mechanism and rotate by 90° to prevent it from engaging again. Open the quick locking mechanism by lifting
the tension lever.
Place the rack, from above, horizontally onto the trailer tow bar. Push the tension lever of the quick locking
mechanism down (force required is approximately 35 - -40 kg) as far as it will go (the lever will remain in the
horizontal position).
Check whether the bike rack is securely and firmly positioned on the trailer tow bar and can no longer be
rotated. If this is not the case, the quick locking mechanism must be readjusted. Lift the lever and remove the
rack from the trailer tow bar. Remove the protective cap of the adjusting screw. Undo the lock nut of the
adjusting screw and rotate the adjusting screw on the quick locking mechanism tighter by a quarter turn.
Then tighten the lock nut again.
Replace the rack back on the trailer tow bar and check whether the rack is securely and firmly positioned on
the tow bar. Repeat the adjustment process until the rack is secure and firm. Push the protective cap back
onto the adjustment screw.
Caution: Always make sure that the lock nut on the adjusting screw is correctly tightened!
Slight signs of pressure on the two bar ball are normal and do not influence the
functionality.
When the rack can no longer be rotated on the trailer tow bar, rotate the securing bolt of the quick locking
mechanism until it engages. Now close the quick locking mechanism with the supplied padlock and remove
the key from the lock. Store the key carefully and in a safe place. The bicycle rack is now secured to prevent
theft.
Lock for brake lever
Hole for padlock
Lever for tipping mechanism
Brake lever
Safety pin
Publicité
