Publicité
Les langues disponibles
Les langues disponibles
Mounting the wheel rails on the base frame
4 x Washer 17.6 x 6.5 x 1.1
Insert the long screws of the wheel rails through the drilled holes of the base
frame. Make sure that the wheel rail with the additional short link screws is
secured at the back of the base frame. Align the wheel rails centrally on the
base frame. Screw the wheel rails into place with the washers 17.6 x 6.5 x 1.1 and wing nuts.
Mounting the lamp mount
Lamp mount, left and right
Join the two parts of the lamp mount together. This is made easier by the small guide element which is
already mounted on one side. Push the two pieces together and secure the connection with the screws M5 x
10 and washers.
Installation of the rear lights
Rear lights, left and right
2 x Wing nut
Insert the left rear light (with fog light) into the left light protection (fixture eye right, cable guide bottom). Pay
attention to ensure that the cable is correctly inside the duct. Now guide the threaded bolts of the light
through the drilled holes on the left side of the lamp mount and screw the rear light firmly into place using the
nuts M5 and washers 13.7 x 5.4 x 0.9. Do the same for the right rear light (with reversing light).
Now mount the entire lamp mount under the second wheel rail. To do this adjust the short link screws in the
second wheel rail to the distance of the lamp mount holders. Guide the screws through the drilled holes in
the holders of the lamp mount and screw into place using the washers 17.6 x 6.5 x 1.1 and wing nuts.
Mounting the license plate holder
Clips
Cut-out for installation clips
Mount the license plate holder using the already mounted Allen screws and washers to the lamp mount in
such a way that the lamps and the license plate holder are level.
The mounting clips for securing the license plate are push-out parts in the holder. Break out two of the clips.
Slide the license plate into the holder, then push the clips into the cut-outs to secure the license plate.
Mounting the frame holder
Frame holder, short
Use the key to open the lock on the knob nut and remove the key. Unscrew the knob nut completely from the
frame holder by rotating anti-clockwise. Now remove the washer, the frame clip and the tube-side spacer
from the thread. Place the thread on a firm and scratch-proof surface and push the cuff and tube carefully in
the direction of the underlay. This releases the lock screw from the cuff and also removes the cover cap. Pull
the lock screw completely from the cuff and separate the tube from the cuff. Open the cuff and remove the
rubber inlay. Place the rubber inlay around the U-bracket in a position suitable for your bicycle (will depend
4 x Wing nut
2 x Screw M5 x 10
Light protection, left and right
2 x Washer 17.6 x 6.5 x 1.1
Frame holder, long
2 x Washer 5.4 x 5.2 x 0.9
4 x Nut M5
4 x Washer 13.7 x 5.4 x 0.9
Publicité
