Publicité
Les langues disponibles
Les langues disponibles
Property damage due to opening tailgate.
The tailgate could hit the bicycle rack and be damaged.
Switch off the electric tailgate and operate it manually.
•
Fold down the bicycle rack before opening the tailgate.
•
Property damage caused by hot exhaust gases.
Damages may be caused to the rack or bicycles if the exhaust outlet is close by.
Use an exhaust deflector if necessary.
•
Personal injury or property damage possible due to a damaged bicycle rack.
Damage to the rack, e.g. by bent parts, cracks or scratches, prevents the safe operation of the rack.
Do not mount the bicycle rack if it is damaged in any way.
•
Follow the steps as described in the chapter on "Maintenance".
•
Personal injury or property damage due to loss of the bicycle rack while driving.
A loose or faulty connection between the bicycle rack and trailer tow bar can lead to the detachment of
the bicycle rack.
Replace a defective trailer tow bar.
•
Clean the trailer tow bar of dirt, dust and grease.
•
Personal injury or property damage possible due to loss of bicycle parts while driving.
Damaged may be caused by parts that can be lost if they come away from the bicycle during the journey.
• Remove all parts that may be lost before starting your journey, these include air pumps, batteries of
electric bikes, battery-powered lamps, navigation systems, bicycle computer, tool bags or baskets.
Personal injury or property damages caused by increase wind loads.
The bicycle rack and trailer tow bar may be damaged by too high a wind load.
Remove all bags from the bicycle before starting your journey.
•
Do not use protective covers for the bicycle during the journey.
•
The general operating permit must be carried in the vehicle when the rack is mounted.
Operating instructions
Mounting the bicycle rack:
The bicycle rack must first be assembled. Take all of the components out of the packaging and set them out
clearly. Check the scope of delivery. Every stage is described and clearly shows which components are
required for the assembly of the rack.
Mounting the U-bracket
Base frame with
Quick closing mechanism
Now fit the U-bracket onto the intended pipe sleeves. Push the lock screws M8 x 60 from the outside,
through the drilled holes of the U-bracket and the pipe sleeves. Place the washers and knob nuts M8 on the
ends of the screws and tighten the knob nuts firmly.
U-bracket
2 x Lock screw M8 x 60
2 x Washer 15.8 x 8.3 x 1.2
2 x Knob nut M8
Publicité
