Nice WG20S Instructions Et Avertissements Pour L'installation Et L'utilisation page 26

LED OPEN [C]
Off
On
LED P1 [D]
Off *
On
Series of quick flashes, from
1 to 4
5 quick fl ashes
1 slow fl ash
3 slow fl ashes
5 slow fl ashes
LED P2 [E]
Off *
On
1 fl ash per second
2 fl ashes per second
LED P3 [F]
Off *
On
1 slow fl ash
2 slow fl ashes
* or it could be in "Standby" mode
24 – English
Stato
Everything OK
OPEN input activated
Stato
Everything OK
Memorisation mode 1
Memorisation mode 2
Deletion OK
Wrong command
Memorisation OK
Deletion OK
Stato
Everything OK
Everything OK
The learning phase has not been carried out or
there are errors in the memory data
Device learning procedure underway
Stato
Everything OK
Everything OK
There is no memorised opening angle
Opening angle learning phase is underway
Azione
OPEN input not active
This is normal only if the device connected to the OPEN input
is active.
Azione
No memorisation underway
This is normal during memorisation mode 1 which lasts maxi-
mum 10 s.
This is normal during memorisation mode 2 which lasts maxi-
mum 10 s.
Deletion of a transmitter successfully completed
Command received from a transmitter which is not memorised
Memorisation successfully completed
All radio transmitters successfully deleted
Azione
"Low" speed selected
"High" speed selected
Some faulty devices may be present; check and if necessary
repeat the device learning phase (see paragraph 10.3.3 "Learn-
ing other devices").
It shows that the search for connected devices is underway (it
lasts maximum a few seconds).
Azione
Cycle operation
Complete cycle operation
Perform the learning phase (see chapter 3.5.2 - Learning the
leaf opening and closing angles)
Opening angle learning phase is underway