Publicité
Les langues disponibles
Les langues disponibles
electric jumpers in the same way) and it is important to check that there
are not any other pairs of photocells with the same address. The photo-
cell address assignment operation is necessary for them to be correctly
recognised among the other devices of the ECSBus and to assign them
their function.
01. Open the housing of the photocell.
02. Identify the position in which they are installed according to fi g. 42
and place the jumper according to Table 8.
Unused jumpers must be placed in the special compartment for
future use (fi g. 43).
03. Carry out the learning phase as described in paragraph 10.3.3 "Rec-
ognition of other devices".
41
Photocell
Photocell h=50 cm; triggered
A
on closure
Photocell h=100 cm; triggered
B
on closure
Photocell h=50 cm; triggered
C
on opening and closure
10.4 - MEMORIZING ALL RADIO TRANSMITTERS
The control unit contains a radio receiver for GTX4 transmitters; the trans-
mitter included in the box is already memorised and ready to use.
There are two ways of memorising a new transmitter:
• Mode 1: in this "mode" the radio transmitter is used as a whole, i.e. all
the keys carry out a preset command (the transmitter supplied with the
WG2S is memorised using Mode 1).Obviously a radio transmitter in mode
1 can only control one single automation; that is:
Key T1
"OPEN" Command
Key T2
"Pedestrian opening" command
Key T3
"Only open" command
Key T4
"Only close" command
• Mode 2: each key can be associated to one of the four commands
available. If this mode is used appropriately 2 or more different automa-
tions can be controlled, for example:
20 – English
42
A
B
43
TABLE 8
Jumper
Photocell on right with activa-
D
tion on opening
Photocell on left with activa-
E
tion on opening
Photocell h=100 cm; triggered
F
on opening and closure
Key T1
Key T2
Key T3
Key T4
Obviously each transmitter is treated separately and for one single control
unit there can be some transmitters memorised in mode 1 and others in
mode 2.
The overall maximum memory capacity is of 150 units; mode 1 memori-
sation occupies one unit per transmitter while mode 2 occupies one unit
per key.
Caution! – As memorisation procedures have a time limit (10 s), it
is important to read the instructions in the next paragraphs before
starting.
Press key P1 [B] (fi g. 44) for at least 3 s. When the LED P1 [A] (fi g. 44)
switches on release the key.
02. Within 10 s press any one key on the transmitter for at least 3 s to
Photocell
"Only open" Automation N° 1 command
"Only close" Automation N° 1 command
"OPEN" Automation N° 2 command
"OPEN" Automation N° 3 command
Jumper
Publicité
