Nice WG20S Instructions Et Avertissements Pour L'installation Et L'utilisation page 27

TECHNICAL SPECIFICATIONS OF PRODUCT COMPONENTS
The product WG20S is produced by Nice S.p.a. (TV) I. In order to improve its products, Nice S.p.a. reserves the right to modify the technical charac-
teristics at any time without prior notice. In any case, the manufacturer guarantees their functionality and fi tness for the intended purposes. Note: all
technical specifi cations refer to a temperature of 20°C.
Model/type
Product type
Adopted technology
Maximum start-up torque
Nominal torque
No-load speed
Speed at nominal torque
Stroke
Maximum frequency of cycles
Maximum frequency of cycles
Application limits
Power supply
Max. absorbed rated power
Ambient operating temperature
Use in particularly acid, saline or
potentially explosive atmospheres
Assembly
Protection rating
Dimensions / weight
Photocells PH100
Product type
Adopted technology
Detection capacity
TX transmission angle
RX reception angle
Useful range
Power supply / output
Absorbed power
Max. cable length
Possibility of address assignment
Ambient operating temperature
Use in particularly acid, saline or
potentially explosive atmospheres
Assembly
Protection rating
Dimensions/weight
Straight gearmotor for WG10SK swing gates
Electromechanical gearmotor for automations of automatic gates and doors
24Vdc motor, helical gear reducer; mechanical release
1800N
600N
0.016 mm/s
0.014m/s
480 mm
26 cycles/hour
15 minutes approx.
The structural design of this product makes it suitable for use on gates with a weight up to 250 kg or leaf
width up to 4.5 m and opening angle up to 130°
24Vdc
1,1A,; on start-up, maximum current is 3.6 A for a maximum time interval of 2 s
-20 ÷50°C (gearmotor effi ciency is reduced at low temperatures)
No
Horizontal with specifi c fi xing plates
IP44
908 x 100 h 117 mm / 10 kg
Presence detector for automations of automatic gates and doors (type D according to standard EN
12453) comprising a transmitter "TX" and receiver "RX
Optical, by direct interpolation of TX-RX with modulated infra-red rays
Opaque objects located on the optical axis between TX and RX, larger than 50 mm and moving slower
than 1.6 m/s
20° approx.
20° approx.
10 m for maximum TX-RX misalignment ±5° (the device can signal an obstacle even in the event of
particularly adverse weather conditions
The device can only be connected to the "ECSBus" networks from which it receives mains power, and
sends the output signals
1 ECSBus unit
Up to 20 m (observe warnings regarding the minimum section and type of cables)
UP to 7 detectors with protection function and 2 with opening command function
Automatic synchronisation prevents interference between the various detectors
-20 ÷ 50°C
No
Vertical, wall-mounted
IP44
64 x 89,2 h 29 mm / 60 g
English – 25