Inserting Batteries Into The Training Computer; Functions Of The Training Computer - FitEngine JHK-15654 Manuel

EN
gency dismount. If training devices are set
up in close proximity to each other, they
can share a clearance space.
You can use the castors on the front base
support (8) to push the training device to
the location you want.
Inserting Batteries into the
Training Computer
PLEASE NOTE!
■ Use only the battery type specifi ed in
the technical data.
■ Take the batteries out of the training
computer if they are dead or if you will
not be using the device for a prolonged
period. This will prevent any damage
caused by leaks.
■ Always replace all batteries together.
Do not use batteries of diff erent types
or brands, or batteries with diff erent
capacities.
■ Remove leaking batteries from the
training computer immediately.
Before the device is fi rst used, two 1.5 V
batteries of the AAA type must be inserted
in the training computer (2). These are not
supplied with the device.
The battery compartment is located on
the back of the training computer.
Before inserting the batteries, check
whether the contacts in the training com-
puter and on the batteries are clean, and
clean them if necessary.
1. Press the catch of the battery com-
partment cover and fl ip it up at the
same time.
2. Insert two batteries into the battery
compartment. Make sure the polarity
(+ / –) is correct.
3. Insert the battery compartment cover
and fl ip it shut.
If the training computer stops working, the
batteries need to be replaced.
20
09552_Inlay_DE-EN-FR-ES-IT_A5_FE_V3.indb 20 09552_Inlay_DE-EN-FR-ES-IT_A5_FE_V3.indb 20
Functions of the Training
Computer
(Picture C)
• The training computer (2) is switched
on by pressing one of the buttons or
by moving the pedals (6). If the training
computer does not display any values
during training, the plug of the con-
necting cable is not inserted in the
connecting socket correctly. Correct
the fit of the plug.
• If the error message ER1 appears on
the display of the training computer (2),
this means that the body fat analysis
has failed. The pulse monitors (3) must
be fully clasped throughout the analy-
sis period.
Button Functions
MODE Button for activating
and deactivating setting
mode and for switching
between the displays
UP / In setting mode:
RECOVERY Button for increasing
the value / switching
between options
During training:
Start / end pulse recov-
ery test
DOWN Button for decreasing
the value / switching
between options
RESET / GO
In setting mode: Button
for resetting the selected
value
In the body fat function:
Button for starting body
fat calculation
At a standstill: Button for
resetting all data
BODYFAT Button for switching to
the body fat function
06.07.2021 12:03:43 06.07.2021 12:03:43