EINHELL GC-SC 18/28 Li Instructions D'origine page 25

subsequently oiled.
•
Regular servicing of the scarifier not only
secures longer endurance and performance,
but also contributes to an accurate and simp-
le scarification of your lawn.
•
At the end of the season, carry out a general
check of the scarifier, and remove all residue
collected. Before the start of every season, it
is absolutely necessary to check the state of
the scarifier. Contact our Customer Service if
repair work is necessary.
7.3 Changing the roller (see Figures 15-19)
Be sure to wear work gloves!
Only replace the roller with a genuine Einhell rol-
ler, as this will ensure top performance and safety
under all conditions.
To change the scarifi er roller or the optio-
nally available aerator roller (Fig. 17, Art. No.:
34.059.41), proceed as follows:
Remove the two socket head screws (Fig. 15 /
Item D). Lift the roller at this end (Fig. 16) and pull
it out in the direction of the arrow. If the holder
(Fig. 17 / Item E) does not exist on the roller you
want to install, remove it from the previously used
roller and fi t it on the roller you now want to use.
Slide the new roller in the direction of the arrow
(Fig. 19) onto the square-ended drive (Fig. 18 /
Item F) and then press it into the holder (Fig. 19).
Use the two socket head screws (Fig. 15 / Item D)
to secure the roller again.
Apply grease to the square-ended drive from time
to time so that the rollers can be changed easily.
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
Replacement cutting unit Art. No.: 34.059.42
Aerator roller Art. No.: 34.059.41
Catch basket Art. No.: 34.059.40
Anl_GC_SC_18_28_Li_Solo_SPK13.indb 25 Anl_GC_SC_18_28_Li_Solo_SPK13.indb 25
GB
8. Storage and transport
Important! Remove the battery.
Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempera-
ture is between 5 and 30°C. Store the equipment
in its original packaging.
Transport
•
Switch the machine off and pull out the safety
plug before transporting it.
•
Fit transport guards if available.
•
For easier transport and/or storage, open
the wing nuts (Fig. 1 / Item 13) far enough to
allow the push bars to be flipped together at
these points. Take care not to damage the
cable and the push bar tubes.
•
Protect the machine from damage and the
strong vibrations that can occur particularly
when transporting in vehicles.
•
Secure the machine against slipping and
tipping over.
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 25 -
07.09.2021 16:13:14 07.09.2021 16:13:14