EQUATION EQ 10 Manuel D'installation, D'utilisation Et D'entretien page 121

PANORAMIC GLASS
The panoramic glass is cleaned by itself during the stove operation; the air touches the inside part of the glass and clean it
from ash and particles.
Is it possible that after working for several hours the glass is dirty inside. This may be due to the quality of the pellets used as
well as a bad circulation of the smoke exit. In this case clean the glass using a cotton cloth soaked with glass cleaning
detergent. We remind you that to perform this operation the stove must be completely cold.
DOOR JOINTS OF THE FIREPLACE
The joint ensures the hermetic enclosure of the stove and also guarantees its smooth operation. It is necessary to check it
regularly and replace it immediately if it is damaged. A technician should perform this operation.
CLEANING THE BOTTOM SMOKE CHAMBER (See photo)
This operation can be more or less frequently depending on the quality of the pellet used and combustion residues
which form.
Open for inspection (fig. 1).
Remove elements of movement and smoke, (fig.2) top and bottom (fig. 3)
It is prohibited to touch the part of the ehaust ̀ ventilation ̀ this component is very delicate and a simple blow can
cause maor ̀ damage (fig ̀ 5). The defective part must be replaced in case of damage during cleaning and warranty
will not pay it.
Cleaning flue tubes on a quarterly basis with a brush (fig. 6 NOT INCLUDED) is recommended.
NO
1
3
5
121
2
4
6