Automatic Cleaning; Cleaning And Maintenance - EQUATION EQ 10 Manuel D'installation, D'utilisation Et D'entretien

5.0 CLEANING AND MAINTENNACE
The cleaning and maintenance operations guarantee a smooth operation of this product over time.
ATTENTION
• Before cleaning, check that the stove and the connection pipes are completely cold.
For cleaning never use flammable products.
•

5.1 AUTOMATIC CLEANING

The stove is equipped with an automatic cleaning system in stead of the manual cleaning system
Press key 6 during approximately 2 seconds and enter into the user menu.
•
• Confirm by pressing again
Cleaning mode will be on
•
The 4 extraction pipes will be cleaned.
•
If the manual cleaning is finished 600 seconds before the automatic cleaning, press key 1 to interrupt the
•
process and return to the user menu.
5.2 SMOKE PIPES CLEANING AND MAINTENANCE
INFORMATION
• A good smoke evacuation system (connections and ducts) is a safety guarantee for the room and the correct
operation of your stove.
We recommend frequent and regular cleaning according to written instructions given by the installer and/or
•
manufacturer of the installed material (required by law to submit this documentation) and according to current standards.
The smoke evacuation duct must be checked regularly and be cleaned by experienced staff, before first ignition or
•
after a long period of non-use.
5.3 STOVE CLEANING AND MAINTENANCE
Cleaning and maintenance operations guarantee a good performance and safety to the product over time. Maintenance must
be done according to the consumption (we recommend performing maintenance after you have used the stove and burned
2000 kg of pellets) and always once a year.
You need to program technical interventions for the maintenance with the technical service support which will have to provide
you with a certificate of conformity for each revision.
Avoid leaving residues of pellet in the stove during non use periods
A correct cleaning of the stove is essential for its proper functioning.
List of the cleaning and maintenance main operations to be carried out by technical assistance:
Cleaning of fan, extractor and environmental fans
•
• Cleaning of all inaccessible places by the user, as well as the fireplace
Verifying the dispenser status
•
Verification of the turning on as well as the pellet load
•
• Control and change of door joint
Remove door gasket and clean the union fitting located at the entrance of the smoke
•
• Parameters control and combustion control.
Intervention declaration certifying the maintenance performance
•
ATTENTION
Do not perform cleaning and maintenance tasks without assuring that stove is completely cold.
EXTERNAL SURFACE
Use a soft cloth and neutral liquid detergent to clean the ceramic parts.
The external parts must be dried with a dry cloth.
Do not use sponges or other material to smoothen the surface.
120