Endress+Hauser RIA452 Manuel De Mise En Service page 67

RIA452
Function (menu item)
Ref. num.
Ref. bargraf
Dec. point
Bar 0%
Bar 100%
Bar rise
Function (menu item)
Ref. num.
Out damp
Out range
Dec. point
Out 0%
Out 100%
Offset
Endress+Hauser
6.3.2 Display - DISPLAY/M2
All the settings for the device display are grouped under this menu item.
Parameter setting
Input
Lintab
Total
Input
Lintab
XXXXX
XXXX.X
XXX.XX
XX.XXX
X.XXXX
-99999..99999
-99999..99999
Right
Left
6.3.3 Analog output - ANALOG OUT/M3
All the parameters available for the output can be found under the analog output menu item which
is marked as ANALOG OUT in the device.
Parameter setting
Input
Lintab
0..99.9
Off
0 - 20 mA
4 - 20 mA
0 - 10 V
2 - 10 V
0-1 V
XXXXX
XXXX.X
XXX.XX
XX.XXX
X.XXXX
-99999..99999
-99999..99999
-999.99..999.99
Description
Selects which value is shown on the display.
• Input = measured value
• Lintab = linearised measured value
• Total = integrated value (can only be selected if the pulse output option is avai-
lable)
Selects the signal source for the bargraph
Number of places after the decimal point for bargraph scaling.
Start value for the bargraph
End value for the bargraph
Bargraph orientation.
• Right = 100% value (rising from left to right)
• Left = 100% value left (falling from left to right)
Description
Selects which value is output at the analog output.
• Input = measured value
• Lintab = linearised measured value
Signal damping of measuring input with 1st order low pass. Time constant can be
selected from 0 to 99.9 sec.
Signal type of output
!
Note!
"Off" switches the output signal off completely.
Number of places after the decimal point for outputting the measured value. Can
be selected for analog signal types
Start value of the output signal
End value of the output signal
Shifts the zero point of the output curve in mA or V.
Commissioning
67