Basic Setup - Hach FL900 Série Flow Logger Manuel D'utilisation De Base

Basic setup

The information in this manual can be used to make a simple program for the logger and to calibrate
the sensors. Refer to the FSDATA Desktop documentation for advanced options. Complete the
sections in the order that they are shown.
Make a basic logger program
A basic program must be written to the logger to specify the channels to be logged.
1. Open a communication session with the logger:
a. Open FSDATA Desktop.
b. Click CONNECT. The Connect to Instrument window opens.
c. Click the FL900 button.
d. Select the port on the computer where the logger is attached (serial or USB), then click
CONNECT.
Note: If the sensor mismatch message is shown, select "Create new program based on sensors
connected."
e. Make sure that the connection status shows "connected".
2. Complete the information in the General Settings tab.
Option
Site Identification
3. Select the channels to be logged in the Select channels to log section:
a. Expand the tree for the Logger channel group. The Power Supply channel is always shown in
this group. Logging the power supply will provide values for the battery level. An alarm could
be set at a specific level to alert the account manager of a low level, thus prompting a field
visit to change the batteries and prevent lost data. If the logger contains a port for a rain
gauge, the Rain channel is also shown. To include a Logger channel in the datalog, select the
check box next to the channel name.
b. Expand the tree for each Port[1](Sensor Name) channel group to view the available channels
for the sensor. If the check box next to Logger or Port[1] is selected, all of the channels in the
group are automatically selected.
c. To include a Sensor channel in the datalog, select the check box next to the channel name.
The log channel count increases each time a channel is selected.
Note: For loggers with multiple sensor ports, the port number is added to the channel name. For example,
Velocity 3 is the velocity channel name for sensor port 3.
4. To set the logging interval for a channel group:
a. Click on the channel group name, for example Port1 (Flo-Dar). The logging intervals are
shown.
Description
Enter a unique name for the site.
English 21