When Switching On The Device; Operating Levels - Burkert 8026 Guide Rapide

Type 8026 - 8036 - SE36
Adjustment and commissioning
Warning
danger due to nonconforming commissioning.
Nonconforming commissioning could lead to injuries and damage
the device and its surroundings.
▶ Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the manual.
▶ In particular, observe the safety recommendations and intended
use.
▶ The device / the installation must only be commissioned by suit-
ably trained staff.
Protect this device against electromagnetic inter-
ference, ultraviolet rays and, when installed outdoors,
the effects of the climatic conditions.
8.2 When switching on the device
If the message "ERROR - This display does not support this
Element - Contact Bürkert" is displayed, the version of the
display module is not compatible with the software version
of the device. Contact your Bürkert reseller.
When the device is switched on or the display module mounted
on the transmitter, the display indicates the software version of the
display. The display then shows the first screen of the Process level.
8.3 operating levels
The device has 2 operating levels:
Process level
This level is used:
• to read the value of the measured flow rate and/or the sensor
input frequency
• to read the values of both volume totalizers
• to reset totalizer 2
• to read both the lowest and highest values of the flow rate or the
input frequency that have been measured by the device since the
latest reset (this feature is not active by default),
• to reset both the lowest and highest values of the flow rate or the
input frequency, if the feature has been activated
• to read the current values emitted on the 4-20 mA outputs
• to know the status of the device and the status of the sensor
thanks to the relevant icons.
English
27