Installation Onto The Pipe; Installation Of A 8026 On A Pipe - Burkert 8026 Guide Rapide

7.2 installation onto the pipe
Danger
risk of injury due to high pressure in the installation.
▶ Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to the nature of the fluid.
▶ Respect the prevailing regulations on accident prevention and
safety relating to the use of aggressive fluids.
7.3 installation of a 8026 on a pipe
Danger
risk of injury due to high pressure in the installation.
▶ Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to the nature of the fluid.
▶ Respect the prevailing regulations on accident prevention and
safety relating to the use of aggressive fluids.
Follow the next steps to install the flowmeter 8026 properly:
7.3.1 install the fitting S020 in the pipe
→
Select a fitting S020 adapted to the fluid velocity.
16
English
Type 8026 - 8036 - SE36
Installation and wiring
To select a fitting, please refer to the chart in the technical
data sheet of the related fitting.
Choose a place for the fitting on the pipe so that:
- air bubbles do not appear in the pipe, in the section around the
sensor (Fig. 5).
- the pipe is always filled in the section around the sensor (Fig. 5).
Correct
Correct
flow direction
Incorrect
Incorrect