Removing The Atomizer Pans; Installing The Atomizer Pans - Hatco IHDCH Série Manuel D'installation

English
d. If the handle extends out into the opening:
• Push the atomizer pan toward the back of the unit until
it stops against the backstop.
Atomizer
Pans
Top edge
of opening
Pan Handle
aligned with
top edge of
opening.
Checking the Atomizer Pans (IHDCH-45 shown)
Pan Support
Atomizer Pan
Heating Element
Atomizer Pan Location (IHDCH-45 shown)
11. Turn on the water supply and check for leaks.
12. Install the product support arms or shelves in the desired
positions.
To install a product support arm:
a. Align the hooks on the end of the arm with the desired
slots on the support bracket.
b. Insert the hooks into the slots, and lower the support arm
until it stops.
To install a shelf:
a. Align the hooks on each side of the shelf with the desired
slots on the support brackets.
b. Insert the hooks into the slots, and lower the shelf until it
stops.
13. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
Form No. IHDCH45M-0619
Front glass and product
support arms removed
for clarity.
Front
Vent Cover
(removed through
sliding door)
Front glass removed
for clarity.

Removing the Atomizer Pans

Use the following procedure to remove the two atomizer pans
located underneath the vent cover at the front of the unit.
1. Make sure the Power I/O (on/off) switch is in the O (off)
position, the power cord is unplugged, and the unit is cool.
2. Remove the vent cover located along the bottom, front of
the unit by reaching in through the rear sliding doors.
3. Locate the atomizer pans inside the opening at the front of
the unit, one on each side.
• The atomizer pans sit on pan supports directly above a
heating element.
4. Remove the atomizer pans. To remove a pan:
a. Reach inside the front opening and grab the pan handle.
b. Start pulling the pan toward the front of the unit while
angling the pan up.
c. Continue to lift and angle the pan up until it is clear of the
front opening.
Removing/Installing the Atomizer Pans (IHDCH-45 shown)

Installing the Atomizer Pans

Use the following procedure to install the atomizer pans.
1. Make sure the Power I/O (on/off) switch is in the O (off)
position, the power cord is unplugged, and the unit is cool.
2. If it is present, remove the vent cover located along the
bottom, front of the unit by reaching in through the rear
sliding doors.
3. Install the atomizer pans. To install a pan:
a. Hold the pan by the handle and at an angle above the
front opening.
b. Lower the pan into the opening and set the front edge of
the pan onto the pan supports located directly above the
heating element.
c. Push the pan toward the back of the unit on the pan
supports until it stops against the backstop.
NOTE: If the atomizer pan does not stop, it was installed
improperly. Repeat step 3 of this procedure.
d. Make sure the handle of the atomizer pan is aligned
vertically with the top edge of the opening.
7
INSTALLATION
Front Opening
Atomizer Pan