Intended Use; Basic Safety Information - Burkert 8025 Manuel D'utilisation

2

inTEnDED uSE

use of the device that does not comply with the instructions
could present risks to people, nearby installations and the
environment.
▶ The flowmeter type 8025, or the electronic module SE35
mounted on a sensor-fitting, is intended to measure the flow
rate of a liquid and to totalize the volume of liquid.
▶ This device must be protected against electromagnetic interfer-
ence, ultraviolet rays and, when installed outdoors, the effects of
climatic conditions.
▶ This device must be used in compliance with the characteristics
and commissioning and use conditions specified in the contrac-
tual documents and in the Operating Instructions.
▶ Only use a device which is in correct operating condition.
▶ Store, transport, install and use the device properly.
▶ Only use the device as intended.
existing restraints
Observe any existing restraints when the device is exported.
4
English
Type 8025 / SE35, battery powered
Intendeduse
3

bASic SAfETy informATion

This safety information does not take into account:
• any contingencies or occurences that may arise during installation,
use and maintenance.
• the local safety regulations for which the operating company is
responsible including the staff in charge of installation.
danger
Danger due to high pressure in the installation.
▶ Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
Danger due to electrical voltage.
▶ Put the power switch to OFF before carrying out work on the
device.
▶ Observe all applicable accident protection and safety regulations for
electrical equipment.
Danger due to high temperatures of the fluid.
▶ Use safety gloves to handle the device.
▶ Stop the circulation of fluid and drain the pipe before loosening
the process connections.
Danger due to the nature of the fluid.
▶ Respect the prevailing regulations on accident prevention and safety
relating to the use of aggressive fluids.