Cleaning The Device; Cleaning The Flow Sensor For The 8025; Replacing The Batteries - Burkert 8025 Manuel D'utilisation

Warning
risk of injury due to non-conforming maintenance.
▶ Maintenance must only be carried out by qualified and skilled
staff with the appropriate tools.
▶ Ensure that the restart of the installation is controlled after any
interventions.
9.1

cleaning the device

The device can be cleaned with a cloth dampened with water or a
detergent compatible with the materials the device is made of.
Please feel free to contact your Bürkert supplier for any additional
information.
9.2 cleaning the flow sensor for the
8025
note
▶ Use a cleaning product that is compatible with the materials the
flow sensor is made of.
▶ Do not use any abrasive acting materials.
note
After cleaning of the flow sensor:
▶ Rince the flow sensor.
▶ Check the seal and replace it if necessary.
35
English
Type 8025 / SE35, battery powered
Maintenanceandtroubleshooting
9.3

replacing the batteries

Warning
burn injury due to the leakage of the chemicals from the
batteries.
▶ If chemicals have leaked out of the batteries, wear gloves to
handle the batteries.
Warning
burn injury due to the leakage of the chemicals from the bat-
teries if the batteries are exposed to high temperatures.
▶ Respect the operating temperature of the batteries.
note
risk of burning due to a short-circuit if the red and black wires
of the terminal block are disconnected and not insulated.
▶ Make sure the wires are insulated when they are disconnected.
Recycle used batteries with respect to the WEEE standard:
2002/96/EC.